Call us to get tree help like tree removal, tree fell, bush grinding, shrub mulching , stump grind and a lot of others in USA.


Call us

Call now +1 (855) 280-15-30






Customers who bought this item also bought.

Sep 15, Re: Removal Tool For Shift Rod Bushing I used a 5/16" rod cut from my kids old crib. Ground one end down to a 1/4" taper and it has worked everytime. No need to trash the bushing. And even if you do thread the bushing it will still work.

The only thing it nwa stump grinding llc centerton ar, 20170 Herndon VA doing is holding the O ring in. The condition of the bushing is not that treecleanup.buzzted Reading Time: 7 mins. Jun 04, 1. Shift rod clip tool; 2. Bushing removal and installation tool; 3. 2 new nylon bushings - (comes with a pouch of synthetic grease) 4.

Tim Frank Vice Admiral.

PDF Instructions; White bushing measures: (In the groove) mm OD, mm ID, width mm. Here is what happens to these bushings when they get old and tired Estimated Reading Time: 4 mins. Dec 27, Simply tap the bushing a few turns, use the puller and it slides right out. I even reuse the bushing as I don’t think the few little threads inside do any harm. Basically after the bushing is set on the o ring the o ring becomes the guide for the shaft, just hafta set it at the right"feel" for treecleanup.buzzted Reading Time: 8 mins.

Find Shift Shaft Bushing Removal/Installation Tool - here. Not Shipping - No Longer Available. Offering discount prices on OEM Mercury Marine parts for over 50 years. The Sierra Shift Shaft Bushing Tool is interchangeable with the following: GLMMercury T,T,Each Sierra product meets or exceeds the original equipment part it replaces/5(13). JIMS Shift Pedal Shaft Bushing Tool - For models listed w/5- or 6-speed transmission. Time-saving tool removes worn shift shaft bushings in Big Twin primaries without having to remove the inner primary.

Tool also will install new bushings to the correct location. Bushings can be swapped out in approximately 20 minutes using this tool - a. Jun 13, I have an 81 Evinrude 25 hp (E25RCIM). I have the shift rod bushing and o-ring on order. I assume the gasket goes in the bottom of the hole where the bushing goes, but where does the o-ring go?

Also, is there some sort of punch I can fashion to get the bushing out, without having to pay +. DORMAN {#E0AZ7FA, EOAZ7FA} Kick Down Rod Bushing; Ford w/ RWD;";";"; EOAZ-7FA; Fits AOD and ATX transmissions Info. Also a gentleman by the name of Frank Robb over at treecleanup.buzz has made some of the tools for servicing the 50's and 60's OMC motors.

Had the bushing removal tool, flywheel puller, flywheel holder and a tool for replacing the O-rings in the dual line fittings.